LM-CANopen® DISPLAY - Load weighing controller

NEW CANopen^® CONTROL UNIT with DISPLAY

The new universal LM-CANopen control with display unit can be used with all sensors manufactured by MICELECT.

This unit uses CANopen® communications protocol and its calibration and configuration is very easy.
8 to 16 inputs models available.

We make different versions with CAN propietary protocol too.

FEATURES:

• MODELS:
  • DIN-rail.
  • In a IP 65-rated plastic box.
  • 8 inputs.
  • 16 inputs.
  • CAN propietary protocol.

• STANDARD FEATURES:
  • CANopen® communications according to Cia 417.
  • Compatible with all load weighing sensors manufactured by MICELECT.
  • Up to 16 individual sensor measures.
  • High sampling speed.
  • Non-connection sensor detection (EMCY codes).
  • CAN-bus connection: DS 303-1 (Open Style Connector or 9-pin D-sub connector).
  • LEDs indicate the status of the node according to DS 303-3.
  • CANopen alarms:
    • Zero-Load.
    • Normal-Load.
    • Full-Load.
    • Overload.
    • Slack rope.
    • Difference of rope.
  • LCD and buttons to view and set all CANopen and manufacturer parameters.
  • Update firmware button through CANBus connector (with PCAN adapter).

ELECTRICAL FEATURES:

Power Supply Voltage	24Vdc
Communications	CANopen
Open Style connectors	DS 303-1
LEDs indicating the status of the node	DS 303-3
2.5 kV rms signal and power isolated CAN transceiver.
isoPower integrated isolated dc-to-dc converter.
Complies with ISO 11898 standard High speed data rates of up to 1 Mbps.
High common-mode transient immunity: >25 kV/μs.
DIP switch 120Ω termination resistor.
Update firmware button through CANBus connector (with PCAN adapter).

MECHANICAL FEATURES:

Weight

1Kg

TEMPERATERE FEATURES:

Operating temperature

-10ºC / 50ºC